Cancel button for Remove/Components when other items are affected

[Hvergelmir]

Hi, this is to suggest a minor improvement -- or at least I think it is an improvement -- for the Remove/Components "tab".

On occasion, if you uncheck an item another item (or more items) will be affected and the following dialog pops up. Now, since this dialog is a direct response to the unchecking, I think it should have the ability to roll back the unchecking, too. Meaning, there should be another button labeled Cancel, which allows me to back out from the removal of the component (and thus leaving other affected items alone and the checkbox checked).

Just an idea.

Thanks for reading and considering.

PS: I would expect the close button in the caption bar to exhibit that Cancel behavior, btw. Not sure if this makes it an unacceptable change.

 

[tistou77]

It's been a long time since I tried this, but the "Close" button (the cross) allows you to cancel, but without certainty.
To be tested.

 

[Hvergelmir]

tistou77 when I use the Close button the item that I just checked (and which brought up the dialog) remains unchecked. So this isn't cancel behavior. It's the No behavior that you get from Close right now.

 

[MacVap]

I was confused too (and maybe still am).

 

[francis11]

After unchecking a Component affecting other components - often driver .inf - just check it again, and it'll come back together with the other components.