Integrate DRP driver pack

  • Thread starter Thread starter Ankit Goenka
  • Start date Start date
A

Ankit Goenka

Guest
is it possible to integrate drp
Driver pack which would also run silently

Plz advice and help
 
Extract all the drivers to a folder, integrate in Drivers tab.

If driverpack runs in silent mode, is possible that no drivers will be installed because of windows "security" rules.
 
Tried doing so
Drp itself is appx 22gb uncompressed
Also if I integrate drivers would the installation copy all drivers on the hard drive?
Increasing installation time?

Please suggest and oblige
 
I would not integrate other than ACPI, AHCI (mass storage), Bluetooth, Card Reader, LAN, USB 3.0, WLAN and finish with ESD compression instead of WIM. For the boot.wim: AHCI and USB 3.0.

Sound and Graphics needs lots of space.
 
@Ankit Goenka, as Kasual said, extract those you need and integrate them on the Drivers page (just drag and drop wanted folders or files from Explorer).

Yes, integrated drivers are on the destination Windows, just not active unless hardware is detected.
 
Kasual said:
I would not integrate other than ACPI, AHCI (mass storage), Bluetooth, Card Reader, LAN, USB 3.0, WLAN and finish with ESD compression instead of WIM. For the boot.wim: AHCI and USB 3.0.

Sound and Graphics needs lots of space.
Click to expand...
Kasual, if I can ask You ? do You do clean install on Windows 10 with internet connection or withut - offline ? why ask - because when add only above to image Windows 10 after reboot will install drivers himself. I always have with this problem :)

regards
 
Venosaur said:
Kasual, if I can ask You ? do You do clean install on Windows 10 with internet connection or withut - offline ? why ask - because when add only above to image Windows 10 after reboot will install drivers himself. I always have with this problem :)

regards
Click to expand...
I keep Windows Update disabled and don't connect to the internet until setup is finished (programs included).
 
Kasual but Windows Update You disabled in NTlite or after install system ?
 
A different idea could be integrate only network drivers to make sure the network works, then use a program like Driver Booster to install the drivers.
 
I don't prefer Driver updater. I always had problems after this using.
 
Or maybe better will be host drivers import ? Do You use this ?
 
Thanks Kasual.
One question yet : When You disable Windows Update service so when do You do activation of Windows 10 ? to do this We need net connection and Windows Update enable.

Regards
 
You must log in or register to reply here.
Back
Top