Splitting WIM file results in Setup cannot locate files error

[JDS]

I have created an image that works fine from an ISO but the wim file is larger than 4gb (too large for fat32). When I try to create the same image using the SWM (split wim file option) on the "apply" page the image will not work. During the install I get the error "... setup cannot locate files ..." about 80% into the installation. Any help is appreciated. Thanks.

 

[JDS]

I'm using NTlite 1.6.0.6164 and creating a win 10 home 1709 x64 image

 

[Kasual]

Have you splitted the image in a bigger size for the firs half of the file?

Splitting images is not supported by Ms after Win 7.

 

[JDS]

Thanks, Yes I did split the wim file because it was over 4 gb. What's the best way to install this image with the large wim file from a USB? I've seen bootable USB programs such as Rufus do they work to create a bootable NTFS USB?

 

[Kasual]

For USB

WinSetupFromUSB

Check the post #17, a short and quick guide to use it.​

For DVD:

The recommended splitting size if you have a 5 GB wim file:
file01.swm 3 GB​

file02.swm 2 GB

Have you tried that way?​

 

[JDS]

It works great from a DVD with the large wim file so I did not try to split that ISO. I was just reading about WinSetupFromUSB I will read that post and give it a try. Thanks for your help!

 

[JDS]

lol post #14

 

[nuhi]

@JDS, Microsoft states that Splitting is not supported on Win10, so your mileage may vary.
I recommend to try the ESD compression on the Apply page - Image format.
Also you can remove components in the Components page, under the "ISO image" branch, without any risk.