Delete disk in installation

[koden]

When i use my install USB created with NTlite it all goes aut. except the disk part.
I have to do manually.

I use my usb on laptops with one disk.
I would like just to erase all on the disk and create new disk with all GB for C drive.

is this the correct way to do? used disk template ... see picture.

Or should I do something in partition?

View attachment 6984

 

[garlin]

We can't read your disk layout from a screen capture

Click on the "two-arrows" icon to extend the Operating System partition.
View attachment 6986
View attachment 6987

 

[koden]

sorry could not get back to that picture again... disk template

But would say this would be the same?

View attachment 6988

 

[garlin]

Type = Primary
Extend = true ✓

 

[koden]

Hi.. not sure what to do...
If I use this (see picture) in installation it says it can install because disk is GPT.
have I maybe set to many parameters, when all I want is to just wipe all and create 1 size disk for a new C drive?

View attachment 7052

 

[koden]

Found this

Disk Partitioning - NTLite Guides

Configure automated disk management for unattended Windows deployments.

www.ntlite.com

Probably what yuo meant with your last comment

Done like the link... first i choosed GPT but pc was setup to legacy.
Removed GPT and it works so far that windows inst. shows disk and I just have to click next
tried to install and next time I also had to format, becuase there was my inst.

is there a way to make installation always format and click next ?

View attachment 7068